Pre-insulated, flexible pipe system with polyethylene service pipes, and PUR thermal insulation.
The advantages of HeatFlex include quick installation, narrow pipe trenches, tight bending radii and the twin pipe system. The highly efficient pipe system alson impresses with an excellent thermal conductivity value of 0.021 W / mK.
For a further reduction in heat loss, a second insulation series with higher insulation is now available.
Pre-insulated, flexible pipe system, with a service pipe made of fibrereinforced, crosslinked polyethylene and PUR thermal insulation.
Thanks to the aramid fiber mesh, the pipe wall thicknesses could also be reduced and, due to the resulting smaller outside diameter, the insulation could be improved.
Compared to conventional flexible pipe systems, media can be transported at a pressure of 10 bar at a continuous operating temperature of + 80 ° C.
Pre-insulated, flexible pipe system with fiberreinforced medium pipe for use up to 115°C and 10 bar.
Thanks to the high temperature aramid fiber mesh, the FibreFlex Pro pipe system can be used up to a maximum operating temperature of 115 ° C and a pressure of up to 10 bar.
The FibreFlex Pro pipe system thus combines the advantages of a flexible pipe system with the operating properties of KMR steel pipe systems and is therefore an innovative, cost-effective alternative.
Pre-insulated, flexible pipe system with fiberreinforced medium pipe for use up to 115°C and 16 bar.
Thanks to the finer-meshed high-temperature fiber mesh made of aramid, the FibreFlex Pro 16 pipe system can be used up to a maximum operating temperature of 115 ° C and a pressure of up to 16 bar.
The FibreFlex Pro pipe system thus combines the advantages of a flexible pipe system with the operating properties of KMR steel pipe systems and therefore represents an innovative, cost-effective alternative.
HeatFlex & PEX Sanitary
PE-Xa pipes (SDR11, SDR7.4) are connected via press or clamp connectors (welding adapters, thread adapters, couplings, bends, T-pieces).
A press tool is required to install the fittings. These can be obtained from RK Infra. No special tools are required to install the clamp connections. The clamping force is applied via the outer sleeve by tightening a clamping screw. A conventional hex wrench can be used for this.
FibreFlex / FibreFlex Pro
FibreFlex / FibreFlex Pro press fittings have an additional polymer crimp sleeve between the sliding sleeve and the service pipe. As a result, the support bushing can be inserted directly into the pipe ends during installation without widening. Up to size 110, standard pressing tools such as for PE-Xa pipes (SDR11) can be used. The RK Infra pressing tool is available for larger dimensions. The pressing point is insulated with joint system.
FibreFlex / FibreFlex Pro factory pre-insulated parts
To reduce welding and assembly work on the construction site, a large selection of pre-insulated steel fittings is available. The FibreFlex / FibreFlex Pro press transitions are welded onto the steel parts and can be pressed directly.
Joint systems are used to insulate connection points.
Half shells for HeatFlex, PEX sanitary, FibreFlex / FibreFlex Pro
Half-shells are available in various configurations for our flexible plastic pipe systems. This innovative CLICK system guarantees the highest construction site quality without time-consuming gluing, screwing or shrinking with secure connection technology and the best thermal insulation properties.